Flowpression

Flowpression is a pneumatic massage system equipped with six powerful pressure chambers. When started, the system fills the chambers with air as they enclose around your legs. Blood flow is reduced temporarily until the pressure releases, letting fresh nutrients and oxygen flow through your legs. A recovery sensation worth experiencing.

A: Sequence Massage

The Flowpression inflates one chamber at a time from the foot towards the hip while holding the previous chamber.

B: 3 Chamber Segment

The Flowpression inflates 3 chambers at a time moving from the foot to the hip.

C: Simultaneous Pressure

All chambers inflate at the same time and then release when desired pressure is met.

D: Hybrid Massage

The first cycle inflates 2 chambers at a time from the foot towards the hip. The second cycle inflates all chambers and then releases when the desired pressure is met.

One size fits all. Maximum thigh circumference is 70cm. The length from heel to the hip is 107cm.

Your Flowpression system includes compression pants, connection tubes, tube extensions, tube covers, remote adapter, remote, charger, backpack, user guide.

Depending on your preference, the Flowpression may work harder which uses more power. It roughly lasts without a charger for 90 minutes.

We recommend 30-60 minutes.

It takes 2 hours for a full charge.

Deflate the boots. Make sure your Flowpression is completely dry. Store in a cool and dry area. Roll the cords and avoid folding them.

You can use it to promote blood flow as a warmup or after a workout. Many athletes use it to enhance their recovery so they are ready for the next workout or competition. It is your own personal massage therapist so you can use it anytime you want.

Do not use it if you have an infection, cardiac issues, acute thrombophlebitis, acute pulmonary edema, deep vein thrombosis(DVT).

Do not use it if you have any wounds, infection, bone fractures, joint dislocations, or tumors at/or near the treatment site.

If experiencing pain, immediately turn off the product.

Please consult your physician if you have cardiac issues, venous and lymphatic issues, pregnancy, and/or any other health issues.

If you experience pain, skin irritation, loss of sensation, or feeling disoriented, stop usage and seek medical advice/attention.

Please consult your physician before use. Flowpression is not intended to diagnose, treat or cure any diseases.

Many pregnant women have used the Flowpression to improve circulation to relieve swelling and soreness. Please consult your physician to see if this is safe and right for you.

To keep your Flowpression clean, we recommend having clean clothes. To clean the boots, make sure you are using a non-chemical spray on a towel and then wipe the inside. Avoid using too much liquid as it can increase the dry time.

Disconnect the compression boots and extension connection. Make sure the tubes are not folded.

When turned on, the Flowpression takes a few seconds to analyze the battery level. It may be half full but the initial indicator will say full. It will adjust in seconds. 

Check if the connection tube points were installed correctly. Check if the arrows on the connection points match up with each other.

Research shows that you get the most benefits at 110mmHg of pressure. Anything over is for the user’s sensation. Some people relax at higher pressure than others.

Plug the charger into the remote. The Flowpression can be used while charging. Make sure the charging cord and unit are placed away from any liquids.

Yes. You want the logo or the tubes to be on the outside of your leg. So a boot with the logo on the left will be for the left leg.

You can use it anywhere that is safe. We recommend that your legs are extended.

We recommend minimal fabric. Athletic wear or compression is ideal. Avoid attire with hard buttons or zippers. Make sure your pockets are empty.

Please consult your physician for more information. You have the option to deselect a certain chamber.

Check that all tubes are fully connected. If air is being leaked, the pressure measurement will not reach the threshold to move on. If your selected pressure is high, sometimes it takes some time to hit the threshold as well.

Air should not be leaking. Make sure that the connections are fully connected. 

In not too many cases, check the rubber rings within the connection to make sure they are not missing or damaged.

Make sure all connection points are fully connected. Check if there is a fold in any of the tubs that can block air from traveling through.